facebook youtube

Product Description

J&M Perf Series Audio KIT 360w RMS 6-Spkrs 06-13 Harley Ultra Classic

# JHAK-HCU06-3606SP

Add to Cart  

In Stock, Will Ship Within 2 Business Days

Drag Specialties - Parts Unlimited Tucker Rocky - Biker's Choice HardDrive

POW !! ---- Blow away those overly-heavy, inefficient bracket-breakin 6.5's your friends are braggin about ,,,,

J&M's new 7 ¼" round drivers are the largest diameter speakers that can be installed into the Harley BatWing style fairing, and vented lower fairings, with cone volume and mass comparable to a 6X9" speaker.

'J&M's 5 ¼" round drivers are the largest & most efficient speakers you can install into the rear trunk pod position on the Harley Ultra.

Both spec'd at 2 ohms impedance and 140/120+ watts max power, these new speakers provide the ultimate in bass response, extended mid/high frequency range and raw audio power.

These are THE most efficient speakers you can buy for your Harley and their mounting hole pattern and spade electrical connections are exactly the same as the factory specification.

Lower fairing speaker housings are custom molded to fit the late model VENTED lower fairing shells, as mounted on the Harley Ultra.

This exciting new J&M 4-channel 360w fairing/rear speaker amplifier kit has been design specifically for use in the 2006-2013 Harley® UltraClassic ElectraGlide fairing with the Harley HK radio.

This is a full range class D amplifier and is spec'd at 90watts RMS per channel X4 channels, (360w total) driven continuous into a 2 ohm load @ 14.4vdc.

Amplifier mounts to the top of the custom made stainless steel bracket system, which has the slots in the bottom section to properly relocate 2 of the Harley CB, MP3 or XM sat radio modules, if installed.

Amplifier gain adjustments are factory preset for this 6 speaker configuration on the Harley Ultra, along with the custom in-series wiring harness for the front upper/lower fairing speaker positions.

Custom made plug-n-play wiring harnesses are included with this amplifier kit, top quality heavy gauge power/ground wires are used for the fused battery connection, along with all necessary mounting hardware & complete installation/operation instructions.

Amplifier itself measures 7 1/4" X 4 ¾" X 1 ¾".